Sequence for a TCU
Procedure:
1. Connect TCU.
This opens the "New operator panel (TCU)" dialog.
2. Select "New" to connect a new TCU and "OK" to confirm.
3. In the next dialog, accept the name suggested by the system or enter a name and confirm
this with "OK".
The following parameters are preselected for the TCU:
4. Restart the TCU to apply the new settings.
5. If you want to change the parameters, select "Main menu" ā "Service this panel" ā "Modify
operator panel settings".
Networking
5.4 Service and diagnostics
TCU 30.3
66 Manual, 09/2017, A5E40874197
To Next Page
Loading...
