Connection example
The digital inputs/outputs are connected appropriately during commissioning.
'5,9(&/L4SRUW
'5,9(&/L4SRUW
'5,9(&/L4SRUW
'5,9(&/L4SRUW
1;1;
0IRUWHUPLQDOV
H[W
9'&
0
0
;;;;
',
',
',
',
0
','2
','2
','2
','2
0
0
9
0
0
0
0
;
;
',
',
1) Rapid inputs must be shielded.
2) Jumper open, electrical isolation for digital inputs (DI)
3) Can be parameterized as either input or output
Figure 8-5 Connection example for the NX10.3 / NX15.3
See also
For the pin assignment of the DRIVE-CLiQ interfaces X100 - X103, please refer to Section
"DRIVE-CLiQ (Page 77)".
For further information on DC voltage and standards, please refer to Section "Power supply
connection (Page 65)".
Connectable components
8.1 NX10.3 / NX15.3
PPU 1740
90 Equipment Manual, 01/2019, A5E47615272B AA
To Next Page
Loading...
