Siemens SIPART DR19 - Page 71

SIPART DR19
C73000-B7474-C140-06
71
Quick Reference Configuring
S89 Analog indicator (3) - allocation of controlled variable
[0]
1
2
3
4
5
6
7
8
9
10
11
e(xd)± 5% bar graph
e(xd)±10% bar graph
e(xd)±20% bar graph
-e (xw) ±5% bar graph
-e (xw) ±10% bar graph
-e (xw) ±20% bar graph
x1 0 to 100% Illuminated moving mark
x2 0 to 100% Illuminated moving mark
x 0 to 100% Illuminated moving mark
wE 0 to 100% Illuminated moving mark
w 0 to 100% Illuminated moving mark
y 0 to 100% Illuminated moving mark
S90 Restart following return of power
[0]
1
Last mode of operation, last w, last y; program controller: time is stored.
Program continues seamlessly with the stored values, if
operating conditions permit.
Manual and internal mode, last w;
program controller: start position (reset state)
YS with K controller, last y with S controller
S91 Optical signalling following return of power
[0]
1
Without PV-X- and SP-W indicators flashing
With PV-X- and SP-W indicators flashing
S92 Serial interface (slot4)
[0]
[1]
1)
2
3
Without serial interface
With serial interface, with interlock of RC
With serial interface, with interlock of CB
2)
With serial interface, without interlock
2)
1)
as of software version -A6 only 0 factory setting
2)
as of software version -C4
S93 Data transmission
Reception via Control signal Source for
DR19 CB
DI
/CB
ES
W
E
Y
N
0 correct only W
EA
Y
N
[1]
1)
configure CB
DI
2 Configure CB
DI
∨ CB
ES
3 Process values CB
DI
∧CB
ES
W
ES
Y
ES
4
2)
Status register CB
DI
∨ CB
ES
5
2)
CB
DI
∧ CB
ES
W
EA
Y
N
1)
as of software version -A6 only 0 factory setting
2)
as of software version -A7
Config.
switch
Setting Function
CONTROLLED VARIABLE OF ANALOG INDICATOR
STARTUP CONDITIONS
SERIAL INTERFACE