Performing basic parameterization
6.3 Drive axes
152 Getting Started, 12/2018, 6SL3097-5AG30-0BP0
Ramp-up/ramp-down time always refers to the time interval from motor standstill to the set
maximum speed (without using roundings).
p1135 OFF3 ramp-down
The OFF3 ramp-down time is effective from the maximum speed down to the motor
● You have completely specified and configured the motor used in the device configuration
of the drive axis.
Note
This basic parameterization cannot be performed without having completed this full
configuration.
"Drive axis > Parameters > Basic parameterization > Optimization runs"
Using the "Optimization run" function, you can calculate motor and controller data for motors
in the motor list as well as for non-listed motors.
● You have completely specified and configured the motor used in the device configuration
of the drive axis.
Note
Specifying third-party (non-listed) motors
When third
-party motors are specified, the motor data must be manually entered (see
Inserting and specifying motors that are missing from the motor list (Page 89)").
Note
This basic parameterization cannot be performed without having completed this full
configuration.
To Next Page
Loading...
Need help?
General