Siemens SITOP PSU100L 6EP1332-1LB00 - Connections and Terminal Designation

Description, device design, dimension drawing
2.2 Connections and terminal designation
SITOP PSU100L
10 Manual, 08.2016, C98130-A7603-A1-2-7629
2.2
Connections and terminal designation
Note
UL requirement: Use suitable copper cables that are designed for operating temperatures of
at least 65
°C/75 °C.
The line input terminals ① can be used to establish the connection to supply voltage. The
output terminals
② are used to connect to the loads to be supplied (see also Section
Installation (Page 31)).
Connections and terminal designations
①
Line input L1, N, PE
One screw terminal each
②
Output +
2 screw terminals
②
Output –
2 screw terminals
*1)
Do not subject the end stop to higher loads
Figure 2-2
Terminal data for 6EP1332-1LB00, 6EP1333-1LB00 and 6EP-1334-1LB00