SITOP PSU100L
Manual, 08.2016, C98130-A7603-A1-2-7629
19
Installing the device in a housing or a control cabinet
SITOP PSU100L power supplies are built-in devices. They must be installed in a
control cabinet where only qualified personnel have access.
The device can be mounted in a control cabinet on standard mounting rails TH35-15/7,5
(EN 60715).
To mount the device, position it with the mounting rail guide at the upper edge of the
standard mounting rail and press down to lock it into place. If this is too difficult, press slider
⑥ at the same time, as described under "Removal".
To remove, pull up the slider ⑥ using a screwdriver (see Figure 3-1 Removal (example,
6EP1334-1LB00) (Page 19)) and disengage the device at the bottom edge of the standard
mounting rail. Then you can remove the device from the upper edge of the standard
mounting rail.
Figure 3-1 Removal (example, 6EP1334-1LB00)
To Next Page
Loading...
