Siemens SITOP PSU8200 24 V/20 A - Connections and terminal designation

Description, device design, dimension drawing
2.2 Connections and terminal designation
SITOP PSU8200/3800 3ph
12 Manual, 05.2018, C98130-A7638-A1-6-7629
2.2
Connections and terminal designation
The line input terminals ① can be used to establish the connection to the supply voltage.
The output terminals
② are used to connect to the loads to be supplied (see also Section
Installation (Page 49)).
Connections and terminal designations
①
Line input L1, L2, L3, PE
One screw terminal each
②
Output +
2 screw terminals
②
Output –
2 screw terminals
④
Signaling contact 13, 14
One screw terminal each
④
Remote contact 15, 16
One screw terminal each
*1)
Do not subject the end stop to higher loads
Figure 2-2 Terminal data for 6EP3436-8SB00-0AY0, 6EP3446-8SB10-0AY0, 6EP3446-8SB00-
0AY0, 6EP3424-8UB00-0AY0 and 6EP3436-8UB00-0AY0
*1)
Do not subject the end stop to higher loads
*2)
16 mm
2
for square crimping, otherwise 10 mm
2
Figure 2-3 Terminal data for 6EP3437-8SB00-0AY0, 6EP3447-8SB00-0AY0, 6EP1437-3BA10 and
6EP3437-8UB00-0AY0