Siemens SITOP UPS1600 - Page 38

Parameterizing the SITOP UPS1600
6.2 Switching off the UPS by a user program when the power fails
SITOP UPS1600 under STEP 7 V5
38 Getting Started,
6. Connect block parameters "UPS_execute_reset" and "UPS_ready_for_reset" (for a
description of the parameters, refer to the table below).
Example: Bit memory "M0.0" or "M0.1" is set for the block parameters.
Parameters
Declaration
Data type
Description
UPS_execute_reset Input Bool Shutdown signal at the
UPS1600
UPS_ready_for_reset
Output
Bool
Signal to run down the system
7. Save your project.