SITRANS P310 with HART
4 A5E35075329-01, 05/2015
This history establishes the correlation between the current documentation and the valid firmware of the device.
The documentation of this edition applies to the following firmware:
Firmware ID (FW) on the nameplate
Installation path for PDM
Scope of the instructions
Table 1-1 "7MF2.33" stands for:
Differential pressure and flow rate, PN 160 (MAWP 2320 psi)
Depending on the variant, the pressure transmitter measures corrosive, non-corrosive and hazardous gases, vapors and
liquids.
You can use the pressure transmitter for the following types of measurement:
● Gauge pressure
● Differential pressure
With appropriate parameter settings and the necessary add-on parts (e.g. flow limiters and remote seals), the pressure
transmitter can also be used for the following measurements:
● Level
● Volume
● Mass
● Volume of flow
● Mass flow rate
The output signal is a load-independent direct current between 4 and 20 mA.
You can install the "intrinsically-safe" or "explosion-proof" version of the pressure transmitter in hazardous areas. The
devices have an EC type examination certificate and comply with the appropriate harmonized European CENELEC
directives.
Pressure transmitters with remote seals of various shapes can be provided for special applications. For example, measuring
high-viscosity substances is a special application.
Operate the device in accordance with the specifications in section Technical data (Page 34).
For additional information, please refer to the operating instructions for the device.
1. Check the packaging and the delivered items for visible damage.
2. Report any claims for damages immediately to the shipping company.
3. Retain damaged parts for clarification.
4. Check the scope of delivery by comparing your order to the shipping documents for correctness and completeness.
To Next Page
Loading...
