Siemens TK 911N2 - Before using for the first time; Putting the appliance into operation

15
en
Important notes
– Fill the water tank
5
only with cold mains
water, and change daily.
– Only place
Nespresso
capsules on the
“balcony”
16
. Other objects may damage
the appliance.
– Do not obstruct the window with objects
or your hand, and do not remove it.
– Do not insert or place any objects on or
in the balcony with the capsule insertion
aperture
16
.
– The
Nespresso
capsules must be
undamaged before use. Capsules which
are distorted or open could jam and
damage the appliance.
Protection against frost
: In order to avoid
the effects of frost, the appliance must be
completely drained prior to transport or
storage.
● Switch on the appliance,
Ready
appears
in the display
● Press the steam button
h
.
● If the display shows
Steam ready
,
remove the water tank and empty.
● Press the steam button
h
once more.
● Wait until the appliance stops pumping.
● Tip the remaining water out of the drip
trays
11
and
12
, and switch the appliance
off at the ON/OFF switch
17
.
NESPRESSO capsules
Use only
Nespresso
capsules with this
appliance.
Address for orders:
Nespresso
-Club, www.nespresso.com
Before using for the fi rst
time
Putting the appliance into operation
● Plug into mains supply.
● Fill the water tank
5
with fresh, cold
water, with the lid
4
removed, or through
the grille in the lid, and mount in position.
● Set switch
17
to
I
. The blue ring
b
surrounding button
a
lights up. Window
2
opens and closes.
● Press button
a
(Stand by). Window
2
opens.
The ex works setting for the display shows
Sprache
and
Deutsch
alternately.
To set a different language, use the button
-
e
or +
f
to select the desired language
and store with steam button
h
.
● To confi rm
English
:
Press the steam button
h
.
● Press button
a
(Stand by).
Wait
will now appear in the display,
followed by
Rinsing
. Appliance rinsing is
performed automatically.
● Rinse the appliance without a
Nespresso
capsule in position. To do this, place a
suffi ciently large vessel under the coffee
dispenser
14
, and press button
f
(large
cup).
● Repeat this procedure 4 times.
● Empty the collecting vessel and place it
under the frothing attachment
9
.
● Press button
g
(hot water), and draw
approx. 0.5 l water, shut off by pressing
button
g
.
The appliance is now ready for operation.
Ready
appears in the display.
Info
: If
English
has already been
confi rmed, and a different language is
desired, see under “Changing basic
settings”.