Siemens TK 911N2 - Messages in the display

23
Messages in the display
Please
and
fill water
fl ash alternately in the display
The water tank
5
is empty.
Fill it with fresh water.
Press button
e
(small cup) and allow water to run into
a cup.
Ready
appears in the dispay again
When preparing regular
coffee, cappuccino or latte
macchiato, the scrolling
message
Fill water and
press button
is displayed
The water tank
5
is empty.
The
Nespresso
capsule is retained in the brewing
system for around 40 sec. Within 40 sec. fill the water
tank 5 and press the button previously selected once
again.
The brewing process is continued.
If the brewing process has been interrupted during the
milk frothing when preparing “Cappuccino” or “Latte
Macciato”, the coffee will be brewed after the water
tank has been filled and the button pressed. Extra
milk can then be added, as described in the section
“Frothing or warming milk”.
Note
: If the process is not continued within 40 sec.,
the capsule is ejected into the capsule container
13
.
Info
: The fact that the capsule remains in place for
longer may have a slight effect on the flavour of the
coffee.
Empty
and
capsules
fl ash
alternately in the display
The capsule container
13
is full.
Dispose of the used
Nespresso
capsules (Fig. 6).
Check
and
container
fl ash
alternately in the display
The drip tray
12
and the capsule container
13
are
missing.
Put the drip tray
12
and the capsule container
13
back
into position.
The display shows
Power
save
The appliance automatically switches to power save if
it has not been used for an hour.
en