Siemens TK 911N2 - Changing basic settings; Descaling procedure

19
Info
: After it has cooled down, immediately
clean the nozzle
10
. Dried residues are
diffi cult to remove. See section “Care and
daily cleaning”.
Changing basic settings
The basic settings can be changed. To
enable this function, buttons
a
(Stand by),
e
(small cup),
f
(large cup),
g
(hot water)
and
h
(steam) are assigned additional
functions.
Button
h
= Access to programming mode
Button
g
= Selector button
for basic settings
Button
f
= Selector button +
(in the basic settings)
Button
e
= Selector button –
(in the basic settings)
Button
a
= Score settings
The following basic settings can be
changed:
– Language – Warming plate
– Water hardness – Rinse
– Power save – Reset
To program the appliance
Info
: The appliance must be switched on.
● Keep steam button
h
depressed for at
least three seconds.
The programming mode is activated.
● By pressing the selector button
g
,
choose the desired setting in the display,
e.g.
Hardness/Level 3
.
● To change the setting, press button
e
- 2
or button
f
+ 4
, e.g.
Hardness/
Level 2
.
● Press button
a
once.
The changed setting is stored.
The display once again shows
Ready
.
To change the language
Sprache/Deutsch
is preset.
The following languages are available:
Deutsch Nederlands
English Español
Français Português
Italiano Русский
To change the water hardness
Hardness/Level 3
is preset.
The following levels are available:
Level 1, 2, 3, 4 or –.
The setting – indicates that no water
hardness level is selected, which means
that the appliance does not automatically
alert the user when descaling is required.
Level
Water hardness level
German (°dH)
French (°fH)
–
1
2
3
4
none
1-7
8-15
16-23
24-30
none
1-13
14-27
28-42
43-54
Power save
The economy mode can be changed from
Power save/On
to
Power save/Off
.
Warming plate
The function of the warming plate
3
can
be switched from
Warmplate/On
to
Warmplate/Off
.
Descaling procedure
The functions
Start descaling
procedure
and
Descaling alarm
reset
are required if descaling is to be
performed, see section “Descaling”.
Rinsing
The user can choose between two settings.
Automatic
= appliance is rinsed
automatically.
en