Siemens TP700 Comfort - Cutter Panel Modes

For more technical support, please go to our website:
www.gillardcutting.com/technical
12
4.1.5 Cutter panel
The rst row of buttons control the machines cutting mode.
From Left to Right:
AutoMode,CameraMode,SensorMode,TimerModeandStop&Cut.
LENGTH MODE:
The cutting length is controlled via an electronic cam; this will perform seamless
cutting length adjustments from 0 to 2500 cuts per minute.
Cut Length (Blue Display):
Length in millimeters/inches of the pieces to be cut.
Length Scaler (Blue Display):
ScalingfactortoadjustenteredcutlengthonHMIandactuallength.
The length factor is used to match the length set on the screen with the actual
length of the cut pieces. Theoretically this value should be 100%. However, different
variables such us material properties, belts, cut ratio, etc. can affect the nal result.
Therefore, this value can be modied to correct this difference.
It should NOT be used to adjust cut length. This is done on the main Home
Screen.