For more technical support, please go to our website:
www.gillardcutting.com/technical
11
SONAR MODE
The analogue input signals act as a trim value on the screen speed to maintain a
steady product ow. For example: if the screen speed is 10 m/m and a 20% value
was entered for the Sonar Value, then an input of 0 volts would produce a speed of
8 m/m and a 10 volts signal would produce a speed of 12 m/m.
Caterpillar belt speed (Blue Display):
Adjusts individually the transport belt speeds calibrated in 0.1 meters per minute.
Lightly tap the screen within the adjustment area to display input panel and adjust
parameter. Press return key to enter the new value.
Sonar trim (Blue Display):
% of the set point speed to slow down or speed up the caterpillar depending on the
external signal. If the external signal is 5v no correction is applied.
Caterpillar belt speed (White Display):
Displaystheactualspeedofthecaterpillar.
Sonar Signal (White Display):
Displaysthe%oftheexternalcontrolsignal(0-100%).
To Next Page
Loading...
Need help?
General
