Siemens TP700 Comfort - Cutter Panel Overview; Batch Operations Overview

For more technical support, please go to our website:
www.gillardcutting.com/technical
8
Caterpillar belt speed (Blue Display):
Adjusts individually the transport belt speeds calibrated in 0.1 meters per minute.
Lightly tap the screen within the adjustment area to display input panel and adjust
parameter. Press return key to enter the new value.
Caterpillar belt speed (White Display):
Displaytheactualspeedofthecaterpillar.
4.1.2 Cutter
Start/Stop Cut Cycle (Left Button):
To start Cutter cycle, press the green button and it will start the knife motor. Cutting
mode is dependent on cut mode switch, see above. As an indication the button will
turn red plus the knife graphic within the symbol will rotate to indicate movement.
Manual Cut Button (Right Button):
When pressed completes one manual cut. Note only operates when machine is out
of cutting cycle.
Mode parameters pre-set (Blue Display):
Adjusts the length, speed or time. Lightly tap adjustment to display input panel and
enter desired value. Press return key to enter the new value.
Actual mode parameter display (White Display):
Displaystheactuallengthorspeed.
4.1.3 Batch
Batch size (Blue Display):
Numberofunitsperbatch.Maximumvalue999,999units.Ifabatchcompleted
beacon is tted on the machine it goes off when the performed cuts number is
equal to the batch size specied.
Performed cuts (White Display):
Numberofcutsperformedbythemachine.Doubleclickonthedisplaytoresetthis
value. If this number reaches the batch size it will be reset automatically.