Siemens WU14UT20NL - Page 43

TroubleshootingNL
Malfunction
Program does not start.
Cause and Troubleshooting
1.Close the door.
2.To start the program, pressStart/Refill.
Child lock is activated.
▶ Deactivate child lock.
→ "Deactivate childproof lock", page 33
Ready in is activated.
▶ Check ifReady in is activated.
→ "Buttons", page 24
Laundry is jammed in the door.
1.Open the door again.
2.Remove trapped laundry.
3.Close the door.
4.To start the program, pressStart/Refill.
Door cannot be
opened.
– – – – is activated.
▶ Resume the programCentrifugeorDrainto choose and
onStart/Refillto push.
→ "Resume program at rinse hold", page 33
Temperature is too high.
▶ Wait for the temperature to drop.
▶ Cancel program.
→ "Program cancel", page 32
Water level is too high.
▶ Select a suitable program for draining.
→ "Programs", page 25
Power cut.
▶ Open the door with the emergency release.
→ "Emergency release", page 49
Washing water is not
pumped out.
Drain pipe or water drain hose is clogged.
▶ Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
trapped.
▶ Make sure that the drain pipe and the water
drain hose are not kinked or trapped.
Drain pump is clogged.
▶
→ "Clean the drain pump", page 36
– – – – is activated.
43