SIFANG CSC-1321 - Time Setting

Human-machine interface and its operation
the up or down key to change its address.
Move the cursor to the receive port or Sending port, and press the up or down
key to change the port number.
Then, press SET to confirm your modification.
To all the above devices, restart its module or the whole device.
3.3 Time setting
Time setting is to set the system clock and automatic time synchronization
function. The interface is shown as follows:
[3] 1/1
Modify Time Sync Time
Figure 22 Interface of CSC-1321 time setting
3.3.1 Clock setting
Move the cursor to “clock setting”, and press SET to enter the following
interface:
[3-1] 1/1
Current time
2013-03-20 16;14;15
Setting time
2013-03-20 16;14;15
Figure 23 CSC-1321 clock setting interface
In initial interface, setting time equals to the current time. When entering this
interface, its current time keeps going as its second beats, while its setting
time suspends for modification. Move the cursor to the figure needed, and
press the up or down key to adjust its figure. Long pressing can accelerate its
changing speed. Then, press SET to confirm your adjustment, QUIT to
cancel
.
3.3.2 Automatic time synchronization
Move the cursor to “Automatic time synchronization”, and press SET to
access the interface shown in Figure 24.