Copyright © Sigicom AB 2020 26
If the instrument is recording transients when Stop monitoring is selected,
the recording will be completed before monitoring is stopped.
6.5. INFRA Net Communication
When INFRA Net communication is mentioned in this document, it refers
to the data transfer between D10/D10 Micro and INFRA Net. The
communication status is displayed in the communication field of the main
screen, see section 4.2.
During INFRA Net communication, all data files on the memory card are
transmitted to the INFRA Net server and automatically removed from the
memory card.
If there are communication problems, D10/D10 Micro will continue to
attempt to communicate with incrementally increasing time intervals
between communication attempts.
6.5.1. Automatic INFRA Net Communication
Automatic communication will be done in the following situations:
• After start or stop of monitoring.
• After a transient recording.
• Scheduled upload.
• When an error has been detected.
To Next Page
Loading...
Need help?
General
