Copyright © Sigicom AB 2020 8
2. Safety instructions
For mounting instructions for INFRA D10 Micro, see Appendix D.
For battery removal and installation instructions, see Appendix C.
2.1. INFRA D10 Li-Ion battery
• Only Sigicom B100 batteries are allowed to be used in INFRA
D10
• Only power supplies provided or recommended by Sigicom, see
chapter 8 Accessories.
• Do not use D10 batteries in other products than applicable
Sigicom products
• Under no circumstances, a charger which can supply more than
20.0V or 2A may be used
• Always keep the batteries at temperatures below 50ºC (122ºF)
• Do not incinerate or disassemble the batteries
• Do not immerse or expose the batteries in water
• If the terminals of the battery are shorted, the battery may
become very hot and permanently damaged
• Use stand-alone chargers in a well-ventilated room, well away
from flammable material, open fire, and electric sparks
• If the battery case is penetrated, it may burn with open flame
• Replacement and other handling of the batteries shall only be
executed by persons who have carefully read the safety
instructions in this manual and its referenced documents.
See Appendix B regarding Battery Transport
To Next Page
Loading...
Need help?
General
