Page 22 User Manual APOLLO
INSTRUCTIONS FOR THE PROPER OPERATION OF THE
ALARM SYSTEM
The security provided by the system that is installed in your
premices, depends on the right selection and placement of the devices it
consists of and on the proper maintenance that you will carry out.
In order for the alarm system to operate properly and rise up to the
purpose it has been bought for, it should, like every electronic device, be
maintained properly and regularly. Furthermore, the user instructions
must be closely followed. We recommend that the test described below
be carried out, at least once every 15 days:
¾ To start with, contact the central station or the police department,
which is connected to the security system, in order to inform them
for the upcoming test.
¾ Arm the alarm system, the way we described in the relative
chapter and, when the exit time ends, open the entrance door.
Wait until the entrance time expires and the siren sounds. If the
siren sounds, enter the [USER CODE] and press [ENTER] to
disarm the system. With this test you confirm that the panel, the
sirens and the entrance contact operate properly.
¾ To test the proper operation of the detectors follow the same
procedure we described and, instead of opening the door, move
around the area protected by the detector, until you hear the siren.
Enter the [USER CODE] and [ENTER] to stop it. Repeat the
same procedure for the remaining detectors and for the doors and
windows, which are protected.
¾ Test, frequently, the operation of the sirens, pressing
simultaneously, for two seconds, the keys [CODE] and
[ENTER], so that you are certain that the sirens of the system
operate properly.
¾ Test the battery voltage of the system, by pressing the [0] key for
2 seconds. On the LED display you will have the battery voltage.
MAINTENANCE
To Next Page
Loading...