Sigma Apollo - OPERATING IN TWO PARTITIONS

Page 18 User Manual APOLLO
open, when the system is disarmed, you may activate the zone’s chime
operation. All the magnetic contacts connected to the relative zones must
be programmed as chime.Chime operation is activated the keypad buzzer
will sound for 1 second, whenever a zone programmed as chime will be
unballanced.
¾ To activate, press [CHIME] until on the LED DISPLAY you will
have the reading: [CH On].
¾ To de-activate, press [CHIME], until on the LED DISPLAY you
will have the reading: [CH OFF].
NOTE: This mode is set up independently in each partition, using the
partition main code. The chime operation is active only, when the panel is
disarmed. Furthermore, the chime zones must be programmed, by the
technician.
DISPLAYING THE CURRENT TIME
To read the Current time, press for 2 seconds, the key [TIME] or
press, [READ] [TIME].
POWER FAILURE (220V) REPORT
When there is an power failure of the 220 V voltage, for a time
period longer than the time programmed by the technician in the relative
setting, then the unit sends to the "FOLLOW ME" telephone number an
intermittent sound signal. This is useful in case it’s necessary for you
have knowledge of the power failure in order to prevent some undesirable
event, such as e.g. damage of food in refrigerators, low voltage of the
system’s battery, etc.
OPERATING IN TWO PARTITIONS
The system may be programmed to operate in two partitions. Each
partition may be armed or disarmed separately using different codes.
In case the system operates in two partitions, the operation of every
partition is the same as described in a simple installation. Following you
will find abilities and functions of the system while operating in two
partitions.