11
2
Configuration
As shown in the navigation overview (section 1.3),
to access the menu item “Set” press ENTER and
then scroll to “Set” by pressing TOGGLE/+.
Finally, press ENTER again.
2.1 Device
The device settings are second down in the “Set”
submenu.
Press ENTER to open the device settings submenu.
This can be used to configure basic settings for
the device, e.g. language, date and time, tones, or
contrast etc.
Press TOGGLE/+ and TOGGLE/- to select the desired
setting and confirm it by pressing ENTER. If you want
to go back a level, press STOP.
After each setting is made, the text “Setting OK”
appears on the display.
2.2 Alarm tones
If the upper target zone limit is breached, the device
beeps three times every 20 seconds (for as long as
you are training outside the zone).
If the lower limit is breached, a longer beep is emitted.
2.3 Key lock
To prevent training sessions from being started by
accident, the buttons can be locked. To do this, select
the “Device” menu and navigate to “Lock”.
To deactivate the lock press any button followed by
ENTER.
2.4 User
The user settings can be found under “User” in the
“Set” submenu.
To access a further submenu within the user settings,
press ENTER.
If, for example, you want to change the “Gender” from
male to female, press ENTER.
“Male” flashes as the current selection and can be
changed to “Female” by pressing the TOGGLE/+
button. Confirm your setting by pressing ENTER.
EN
To Next Page
Loading...
