4
1.2 Button functions
The RC MOVE has five buttons:
TOGGLE/-, TOGGLE/+, STOP, START, and ENTER
STOP button:
This button takes you back a level
within the menu structure.
In training mode, stop the training
session by pressing this button.
Resetting training data without
saving:
Press and hold the STOP button.
TOGGLE/- and
TOGGLE/+ buttons:
TOGGLE/+ enables you to navigate to the
right in the main menu; TOGGLE/- takes
you back again. If you are at a point at which
values can be configured, use TOGGLE/+
to set a higher value and TOGGLE/- to set
a lower value.
Activating/deactivating the light mode
Press the TOGGLE/- and TOGGLE/+
buttons simultaneously. Pressing the
buttons simultaneously a second time
switches the display backlight off again.
The light stays on for approx. three seconds.
START button:
Press the START button to start
training.
Pressing the START button again
while training marks a lap.
If you have paused a training
session by pressing the STOP
button, you can restart the timer by
pressing the START button again.
Lap view:
Press and hold the START button.
Press the STOP button to exit
lap view.
ENTER button:
Use this button to access the
main menu and confirm the entries.
You can navigate in the submenu
of the applicable menu item and
access any further sub-items
available.
To Next Page
Loading...
