3
1
Display, button functions,
and navigation in the overview
Waking up the device:
You will receive your RC MOVE in transport mode to
conserve the battery and must therefore wake it up
before its first use. This can be done as follows:
To exit transport mode and activate the RC MOVE,
please press and hold START for at least five seconds,
as shown on the foil.
“Language English” then appears. Press ENTER
followed by TOGGLE/+ to select the desired language
and confirm by pressing ENTER again.
Pairing:
Before using it for the first time, you must pair your
R1 BLUE transmitter with the watch. To do this, put
on the R1 BLUE chest belt and press TOGGLE/+ on
the RC MOVE until “Pairing” appears on the display.
Now press ENTER to start the pairing process. Once
pairing is complete, a numerical combination appears.
1.1 Display layout
The display is basically divided into three areas:
Area 1: Presentation of the (training) values –
heart rate and laps
Area 2: Presentation of the currently selected
functions, menu items, and the
applicable data
Area 3: Scrolling information for clear menu
guidance and navigation
EN
To Next Page
Loading...
