19
To start a new lap, press START again.
Stop the training session by pressing STOP.
To continue a training session that you have paused,
press START again.
To completely end a training session, press STOP
again. A message will appear on the display to inquire
whether you really want to end and therefore save the
training session (by pressing STOP) or to continue it
after all (by pressing ENTER).
If you want to end the training session without saving
it, press TOGGLE/+ and select RESET/EXIT. Confirm
by pressing STOP.
To train in a customized training zone (OWN 1-3),
you must have previously have selected and set up
the OWN 1 as described in section 2.5.
You can set up a total of three individual zones.
If you want to train without a training zone, select
training zone “OFF”.
Next, press ENTER to open the training view.
3.1 Starting, pausing, continuing,
and ending training sessions
Lap training (LAP)
Start training by pressing START.
Example: You regularly run two laps of a lake and want
to do so at different speeds. The lap training function
on the RC MOVE enables you to determine the values
for each lap.
EN
To Next Page
Loading...
