E2 / D2 Disassembly and disposal
Technical changes reserved - 43 -
8 Disassembly and disposal
CAUTION! Risk of injury!
Never remove the device from a plant in operation.
ª Make sure that the plant is shut down professionally.
Before disassembly:
Prior to disassembly, ensure that the equipment
is switched off.
is in a safe and de-energised state.
is depressurised and has cooled down.
Disassembly:
ª Watch out for any leaking media. Take appropriate precautions to collect them.
ª Loosen the pressure connection shank with an open-end wrench (WAF 27).
ª Manually turn the E2 / D2 out of the measurement setup.
Disposal:
In conformance with the 2002/95/EC (RoHS) and 2002/96/EC (WEEE) directives, the device
must be disposed of as electrical and electronic waste.
Observe the legal regulations of the country in which the device is marketed.
NO HOUSEHOLD WASTE!
The E2 / D2 consists of various different materials. It must not be disposed of with
household waste.
ª Take the E2 / D2 to your local recycling plant
or
ª send the E2 / D2 back to your supplier or to SIKA.
To Next Page
Loading...
Need help?
General
