E2 / D2 Device description
Technical changes reserved - 29 -
Scope of delivery:
Before using the device, check the delivered items:
1x E2 / D2 according to the order data.
1x Operating manual.
Packaging or transport protection (if applicable).
1.1 Intended use
The digital manometer E2 / D2 is intended solely for inspecting, adjusting and calibrating
pressure measuring equipment.
Do not use the reference E2 / D2 outside the specifications and do not disregard the operat-
ing instructions.
WARNING! No safety component!
the reference E2 / D2 is not a safety component in accordance with Directive 2006-42-EC
(Machine Directive)..
ª Never use the reference E2 / D2 as a safety component.
The operational safety of the device supplied is only guaranteed by intended use. The speci-
fied limits (J § 9 "Technical data") may under no circumstances be exceeded.
This applies especially to the compliance with the permissible full-scale reading and the
permissible temperature range.
DANGER! Risk of injury or material damage in the case of excessive pressure!!
Exceeding the maximum overload values can lead to material failure of the digital ma-
nometer. At the same time, that can cause serious harm to health.
ª Make sure that the overload values are never
exceeded.
Before ordering and installation, check that the reference is suitable for your applications.
1.2 Exclusion of liability
We accept no liability for any damage or malfunctions resulting from incorrect installation,
in-appropriate use of the device or failure to follow the instructions in this operating manual.
To Next Page
Loading...
Need help?
General
