Oiling the machine
Bring the upper looper to its highest position by
turning the hand wheel. After every cleaning of the
machine, oil the points shown with the oil included in
the accessories. One or two drops of sewing machine
oil are sufficient. All other parts are made from
special materials and do not need to be oiled.
Cleaning of the machine
Remove the top cover hook or decorative thread
guides. Remove the trim catcher, open the front
cover and the swivel table. Disengage the upper knife.
Remove the presser foot and the needle plate. With
the lint brush provided in the accessory box, remove
lint from the upper and lower knives, the differential
feed and the looper area.
Turn off at the power switch
36
Care of the machine
Cleaning rubber feet
Clean the rubber feet of the machine with methyl
alcohol from time to time. This will ensure that the
machine will not move on the surface on which it is
standing.
To Next Page
Loading...
Need help?
General
