EasyManua.ls Logo

Silvercrest 86208 - Initial Start-Up

Silvercrest 86208
123 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
66
SKM 500 A1
GB
MT
WARNING! RISK OF INJURY!
Caution: the cutting knife, the cutting, shredding and grating discs and the
mixing knife ar
e extremely sharp! For this reason, take care when cleaning.
Caution: the cutting knife, the cutting, shredding and grating discs and the
mixing knife ar
e extremely sharp! For this reason, take care when emptying
the mixing bowl and the blender.
When the appliance is operating, do not put anything other than the ingre-
dients to be processed into the mixing bowl or the blender.
Do not put hands and foreign objects in the to fi lling shaft or the mixer to
avoid the risk of injury or damage to the appliance.
Do not change accessories unless the drive is stationary and the mixer is
unplugged fr
om the power supply! The appliance will run on for a short
time after being switched off !
Never leave the appliance unattended!
Before changing accessories or additional parts that are in motion during
oper
ation, the appliance must be switched off and disconnected from
mains power.
CAUTION - PROPERTY DAMAGE!
Never fi ll the blender with boiling fl uids, such as soup! Allow these to cool
until luk
ewarm.
Initial start-up
Clean the appliance as described in the chapter “Cleaning and Care”.
Place the appliance on a fl at and clean surface.
Attach the appliance to the subsurface with the suction cups so that it is fi xed.
Unwind the power cord from the cord storage a and then attach it to the
cable leadthr
ough.
Assemble the appliance as described in the chapter entitled “Assembly”
depending on the t
ype of use.

Table of Contents

Related product manuals