77
SKM 500 A1
GB
MT
NOTE
► Disconnect the holder with mixing knife 9 from the blender 7 for cleaning!
► Rotate the blender 7 until the arrow on the blender 7 is pointing at the
symbol
on the holder 9. The blender 7 can then be released from the
holder 9.
► Remove the sealing ring 8 from the holder: Slightly lift the sealing ring 8
with a fl at, blunt object (e.g. made from wood) and then carefully guide
the sealing ring 8 over the knife.
Never use sharp or pointed objects for removing the sealing ring 8!
These can damage the sealing ring 8 and therefore cause leaks!
To assemble, place the sealing ring 8 back into the holder 9 and place
the blender 7 onto the holder 9 so that the arrow on the blender 7 is
pointing at the symbol
on the holder 9. Rotate the blender 7 until the
arrow is pointing at the symbol
.
■ Only clean the motor block o, the po
wer cord and the knife guard for the
cutting knife d with a damp cloth. Dry everything properly before re-using it.
■ Clean the holder with mixing knife 9 and the sealing ring 8 in w
arm
dishwater. Afterwards, rinse all parts with clean water so that no detergent
residue remain on the parts.
■ Clean the cutting knife t, the kneading knife r, the disk adapter e, the
shr
edding disk 0, the grating disk q and the cutting disk w, the emulsifying
disc 4, the lid 3 with pusher 1, the mixing bowl u, the drive shaft i, the
drive shaft adapter z, the blender 7, the blender closure 5, the blender
lid 6 and the dough scraper s in warm dishwater. Afterwards, rinse all
parts with clean water so that no detergent residue remains on the parts.
– You can also clean these parts in the dishwasher! If possible, place the
par
ts in the top basket of the dishwasher. Ensure that the parts are not
trapped in any way.
■ Dry all parts thoroughly before re-using the appliance.
To Next Page
Loading...
