8
8 Installation
8.1 Installing the device
Note:
Please observe the following safety instructions for the connection of the device:
Read the entire installation section before connecting the device.
Disconnect the negative pole of the vehicle battery for the duration of the installation.
Observe the safety instructions by the vehicle manufacturer during this task.
If you need to drill holes for the installation, make sure that no parts of the vehicle are damaged.
The cross section of the plus and minus cable may not be less than 2.5 mm².
Do not connect any plugs or cables from the vehicle to the radio without the appropriate expertise!
Only use the supplied cable to connect the device.
Depending on the build of your vehicle, the installation may deviate from this description.
We do not assume any liability for damages caused by faulty installations or connections, nor any subsequent damages.
Illustr. 8.0
Illustr. 8.1
Illustr. 8.2
To Next Page
Loading...
Need help?
General
