Silvercrest KH 2450 - Switching the Voice Recorder O; Recording Dictation

16
7.2 Switching the voice recorder o
Hold the button »ON/OFF«
a
pressed down until »O« appears in the display
q
.
e voice recorder then switches itself o.
7.3 Recording dictation
1
Switch the voice recorder on by pressing the button »ON/OFF« once.
As soon as the start screen is shown in the display
q
:
2
Place the multi-function slider
h
at » STOP«.
3
en select, by pressing the function button A
w
, »NEW«. e voice recorder
now allocates a new dictation reference with a successive number.
‹
]
NOTICE:
›
Every new dictation recording is saved under a new, successive number. However, take note: The numbering
of saved dictations does not subsequently change when you delete individual dictations.
‹
Ú
EXAMPLE:
›
You start a new dictation recording. This is automatically assigned the number »DICT«. At a later date you
delete dictation recording »DICT«. When you start a new dictation recording, this one is automatically as-
signed the next following number, »DICT«, although the dictation with the prior number, »DICT«, has
been deleted.
You can however reset the dictate counter back to null. After the resetting of the counter, the subsequent dic-
tations will again be automatically successively numbered, beginning at »DICT«. The resetting of the in-
ternal counter for dictations is explained in chapter . » Resetting the internal dictation counter«.
However, the dictation recording does not start immediately, instead, at rst it is in
a pause-mode. e status lamp »DICT
«
d blinks; in the display q
is indicated:
Bedienungsanleitung KH 2450 EN.indd 16 23.12.2008 23:09:40