Silvercrest KH 2450 - Switching Audio Signals On;Off

42
OK ESC
Manual
after 10 min
after 30 min
6
Select, by pressing the function buttons B
e
resp. C
r
, your preferred setting.
Subsequently select, by pressing the function button D
t
, »OK«; In the dis-
play
q
the Menu is once again shown. To return to the start screen: select, by
pressing the function button A
w
twice in succession, »ESC«.
8.9 Switching audio signals on/o
is voice recorder is equipped with two types of audio signals:
Ú
Ack. beep (e.g. aer switch-on of the voice recorder, as soon as the start screen
is shown.)
Ú
Audio warning (e. g. discharged batteries/cells)
From the factory all audio signals are switched on. However, you can separate both
warning and ack. beep tones from each other manually, for switch-on and switch-
o purposes. To do this:
1
Switch the voice recorder on by pressing the button »ON/OFF«
a
.
As soon as the start screen is shown in the display
q
:
2
Place the multi-function slider
h
at » STOP«.
3
en select, by pressing the function button D
e
, »Menu«. In the display
q
is
indicated:
Bedienungsanleitung KH 2450 EN.indd 42 23.12.2008 23:09:44