What to do if the card reading device on my Silvercrest SAB 160 A1 Car Receiver does not read the cards?
If the card reading device on your Silvercrest Car Receiver isn't reading cards, check the card itself. Ensure it isn't defective or dirty, and that it's properly inserted with the inscribed side facing to the right. Also, confirm that the data carrier has been formatted to the FAT32 file system.
What to do if my Silvercrest SAB 160 A1 Car Receiver's USB port does not function?
If the USB port on your Silvercrest Car Receiver isn't functioning, ensure that you are connecting a device that adheres to the USB standard. Also, verify that the data carrier is formatted for the FAT32 file system, as the USB port is intended for devices that function according to the USB standard.
Why are the function buttons not functioning on my Silvercrest Car Receiver?
If the function buttons on your Silvercrest Car Receiver are not functioning, it could be due to a malfunction with the device. Try pressing the RESET button. Alternatively, the face plate may not be correctly installed; check to ensure it is properly installed.
What to do if the CD jumps in my Silvercrest Car Receiver?
If the CD jumps in your Silvercrest Car Receiver, it could be due to the mounting angle exceeding 30°; correct the mounting angle. Additionally, the CD might be very dirty or defective, so try cleaning it or inserting a different CD.
Why is the station memory not functioning on my Silvercrest Car Receiver?
If the station memory is not functioning on your Silvercrest Car Receiver, the connection 4 in the ISO block A (Permanent positive) might not be connected correctly. Check the cable connections.
What to do if my Silvercrest Car Receiver CD won't load or eject?
If your Silvercrest Car Receiver CD won't load or eject, consider these potential causes: * Ensure that a CD isn't already inserted. * Check that the CD is inserted with the inscribed side up. * The CD might be dirty or defective; try cleaning it or using a different CD. * If the temperature in the vehicle is too high, allow the vehicle to air out. * Condensation on the laser lens might be the issue; switch the device off for a few hours and then try again.
Why is the radio and/or automatic station saving not functioning on my Silvercrest SAB 160 A1?
If the radio and/or automatic station saving isn't working on your Silvercrest Car Receiver, check that the antenna cable is correctly connected. If the connection is correct, the station signals may be too weak, in which case you should try setting the station manually.
What to do if my Silvercrest SAB 160 A1 Car Receiver will not switch on?
If your Silvercrest Car Receiver won't switch on, there are a couple of things you can check. First, make sure the ignition is switched on by turning the key. If the ignition is on and the device still doesn't power up, the fuse might be defective and needs replacement.
General| Brand | Silvercrest |
|---|---|
| Model | SAB 160 A1 |
| Category | Car Receiver |
| Language | English |
Important safety information, general warnings, and guidelines for intended device usage.
Safety measures concerning laser radiation and safe operation in traffic conditions.
Information on connecting the device, including ISO connection configuration.
Detailed steps for mounting the bracket and connecting to vehicle's ISO plugs.
Adjusting audio characteristics, advanced multi-controller functions, and radio features.
Restoring defaults, tuning, saving stations, AF, regional programs, and PTY search.
Connecting via Bluetooth, making calls, managing caller lists, and streaming audio.
Table listing common defects, their causes, and solutions.
To Next Page