13GB
z Operation
NOTES:
Use suitable pots or pans with flat, even
bases in order to achieve better heat
transmission.
Use pots or pans matching the hob diameter.
The product emits a beep each time a button
is pressed.
Switching on standby mode
Place a filled pot or pan on the heating
zone
[2].
Connect the power plug [1] to a suitable
socket-outlet.
The product emits a beep.
All indicators on the control panel
[] flash
for 1 second.
The display
[] shows -L-.
The product is in standby mode.
NOTE: When the temperature of the
heating zone
[2] is higher than 60 °C, the
display
[] shows -H-.
Switching on program selection
mode
Press and hold [6] for 2 seconds.
lights up.
The display
[] shows ON.
The product emits 1 beep.
The product is now in program selection
mode.
Select a cooking mode
(see “Cooking modes”).
NOTES:
Switching back to standby mode:
Press
[6].
If no cooking mode is selected for
30 seconds, the product automatically
switches to standby mode.
z Power level and temperature
setting
Adjust the following values:
– Power level (in 200 W increments)
– Temperature (in 20 °C increments)
Press +
[4] or – [].
Button Power/temperature
+
[4]
Increase power/
temperature
(max. 2000 W,
240 °C)
–
[]
Decrease power/
temperature
(min. 200 W,
60 °C)
z Timer
NOTE: Check the availability of the timer
in the desired cooking mode: Refer to the
“Cooking modes” table
Select a suitable cooking mode
(see “Cooking modes”).
Enter the timer:
Press
[].
Default time:
30 minutes
Adjust the timer:
– Press + [4] or – [] for 1 minute
increments.
– Press and hold + [4] or – [] for
10 minute increments.
Button Setting the timer
+
[4]
Increase time (max. 3 hours)
–
[]
Decrease time (min. 1 minute)
Activating the set timer: Press [] again
or wait for 5 seconds for the timer to activate
automatically. The set time flashes 4 times in
the display
[].
For the remainder of the set time, the display
toggles between the set power/temperature
and the remaining cooking time.
To Next Page
Loading...
Need help?
General
