12
GB
9.2 Using and removing the blade
assembly
The blade assembly18 is used to chop food.
The blender jug5 must never be used without the blade as-
sembly18, since the blade assembly18 seals the blender
jug5 on the bottom.
DANGER! Risk of injury from cutting!
~ Please remember that the blades of the blade assem-
bly18 are very sharp. Never touch the blades with
your bare hands in order to avoid cuts.
In order to remove the blade assembly18, proceed as fol-
lows:
1. Position the blender jug5 horizontally.
2. Press the unlocking lever25 on the under-
side of the blender jug5 so that it points to
the open lock symbol.
3. Pull out the blade assembly18 carefully to-
wards the top.
In order to insert the blade assembly18, proceed as fol-
lows:
4. Position the blender jug5 horizontally.
5. Insert the blade assembly18 from the top.
Please take note that the two cams at the base of the
blade assembly18 must be pushed through the two
recesses in the underside of the blender jug5.
CAUTION:
~ Ensure that the seal17 is properly positioned on the
blade assembly18, since otherwise the contents
might escape.
6. In order to lock the blade assembly18,
move the unlocking lever25 on the under-
side of the blender jug5 so that it points to
the closed lock symbol.
NOTE: chop large pieces into smaller ones with an edge
length of approx. 3 - 4 cm before putting them into the
blender jug. Otherwise larger pieces might get stuck in the
blades.
9.3 Insert blender jug
1. Place the blender jug5 into the holder11. The front
side with the pot mark points towards you.
2. Press the blender jug5 slightly downward until the
cog wheel of the blade assembly18 locks in place in
the gear ring of the holder11.
NOTES:
• If the blender jug5 cannot be pressed downward,
“wobble” slightly so that the cog wheel of the blade
assembly18 in the blender jug5 will slide into the
gear ring of the holder11.
• Should the blender jug5 not be positioned correctly, a
safety mechanism prevents the functioning of the de-
vice.
9.4 Insert and remove the mixer
attachment
The mixer attachment20 serves to mix liquid foods, e.g.
to whip cream, beat egg whites, emulsify (e.g. mayon-
naise).
The mixer attachment20 is put onto the blade assem-
bly18:
- The wings of the mixer attachment20 are located in
the spaces between the blades.
- For further notes: see “Overview of functions” on
page 9.
__317552_MC-Connect_GB.book Seite 12 Donnerstag, 21. März 2019 10:53 10
To Next Page
Loading...
