32
GB
Blade assembly18
1. Remove the blade assembly18 from the blender
jug5 (see “Using and removing the blade assembly”
on page 12).
2. Pull seal17 off the blade assembly18.
3. Insert the cleaned seal or a new one.
4. Before using the device again, reinsert the blade as-
sembly18.
Deep steamer attachment3
1. Pull seal4 off the underside of the deep steamer at-
tachment3.
2. Insert the cleaned seal4 or a new one into the deep
steamer attachment3. The raised area must be visi-
ble after insertion, see figure below. Ensure that the
seal is in continuous contact with the surface without
any waves.
Lid of the blender jug23
1. Pull seal22 off the underside of the lid for the blend-
er jug23.
2. Insert the cleaned seal22 or a new one in the lid for
the blender jug23.
17.5 Cleaning, checking and
replacing the spatula
The spatula21 is provided with a detachable silicone
scraper.
For cleaning, remove the silicone scraper, and check it for
damage. Pay attention to changes (e.g. porous material or
tears).
- Both parts can be cleaned in the dishwasher.
- A new silicone scraper can be reordered (see “How to
order accessories” on page 34).
17.6 Descaling
When steaming with hard water, limescale may build up
on the parts used, especially in the blender jug5.
Normal cleaning
In most cases, the limescale deposits are removed by
cleaning in the dishwasher or by hand.
Slight limescale deposits
1. Remove slight limescale deposits, which cannot be re-
moved with normal cleaning by hand or in the dish-
washer, with a towel on which you put some
household vinegar.
2. Rinse with clear water.
Major limescale deposits
CAUTION:
~ Do not use commercially available descaling agent,
not even glacial acetic acid or vinegar essence. Use
the following gentle method.
1. Prepare a mixture of 50% white household vinegar
and 50% boiling water.
2. Fill this mixture into the blender jug5 or put other
furred-up parts into a container with this mixture.
3. Allow the mixture to react for 30 minutes.
NOTE: more extended reaction periods do not improve
the limescale deposits but may damage the parts perma-
nently.
4. Rinse with clear water.
5. Allow the parts to dry completely before using them
again.
17.7 Storage
Store the device so that it is protected against dust and dirt
and out of the reach of children.
__317552_MC-Connect_GB.book Seite 32 Donnerstag, 21. März 2019 10:53 10
To Next Page
Loading...
