Silvercrest SRH 5 C3 - Connecting the power supply

■ 12 │ GB
│
IE
│
NI
SRH 5 C3
Requirements for the set-up location
NOTE
► Do not place the device directly onto varnished furniture. The rubber feet of
the device contain chemical softeners that may attack varnished surfaces.
Use a mat if you want to place the device on a varnished piece of furniture.
For safe and trouble-free operation of the device, the set-up location must fulfil
the following requirements:
■ Place the device on a firm, flat and level surface.
■ Position the device so that the speaker
9 and the bass reflex opening q
are not covered.
■ Do not operate the device in a hot or very wet environment or in the vicinity
of combustible materials.
■ The power socket must be easily accessible so that the plug of the mains
adapter can be easily disconnected in an emergency.
Connecting the power supply
ATTENTION
► Before connecting the device, compare the connection data on the name-
plate of the power supply unit (voltage and frequency) with those of your
mains supply. These data must match to prevent damage to the device.
♦ Connect the supplied mains adapter to the mains adapter connection
r
and to a mains socket. The device is now in standby mode.
Aerial
♦ Pull out the telescopic aerial 0 completely for DAB+ and FM reception.