Silvercrest SRH 5 C3 - Automatic Switch-Off (Sleep Function)

■ 26 │ GB
│
IE
│
NI
SRH 5 C3
♦ When the nap time has elapsed, an increasingly loud alarm sounds.
NAP flashes on the display
1 and the set alarm time is displayed.
Deactivating the nap timer
♦ When the alarm goes off, press any button to end the timer.
NOTE
► To turn off the timer before the end of the alarm time, call up the NAP func-
tion as described in the section Setting the nap timer. Set the alarm time
to 000 and press the VOLUME |
ENTER / SCAN dial6 to confirm
the selection. The nap timer is now deactivated.
Automatic switch-off (Sleep function)
You can use the sleep function to automatically switch the device off after
10–120 minutes.
♦ During ongoing operation, go to the System menu and press the TUNE+
8
or TUNE−7 button (several times if necessary) or turn the VOLUME |
ENTER / SCAN dial6 until Sleep appears on the display 1.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
♦ Press the TUNE+
8 or TUNE−7 button several times or turn the
VOLUME | ENTER / SCAN dial6 to select the switch-off time
(Off, 10, 15, 30, 45, 60, 90, 120 minutes).
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
After exiting the system menu, S appears on the right of the display
1
followed by the remaining minutes or seconds.
♦ After the set time, the device will switch itself off automatically.
♦ To disable the Sleep function, select the setting Off as described above and
press the VOLUME |
ENTER/SCAN dial 6 to confirm the selection.