Silvercrest SRH 5 C3 - System menu (System)

GB
│
IE
│
NI │ 25 ■
SRH 5 C3
♦ Turn the VOLUME | ENTER / SCAN dial6 anticlockwise to the
lowest volume level.
♦ Plug the jack plug of the headphones into the headphone socket
e
on the rear of the device. Sound playback now takes place only via the
connected headphones.
♦ Set the desired volume using the VOLUME |
ENTER / SCAN dial6.
System menu (System)
NOTE
► The system menu can be called up during operation and also in standby
mode.
► If no setting is made in the system menu within 20 seconds, the device exits
the settings menu.
♦ Press the INFO/MENU button
4 for approx. 2 seconds.
♦ Press the TUNE+
8 or TUNE−7 button (several times if necessary) or
turn the VOLUME |
ENTER / SCAN dial6 until System appears on
the display
1.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
Nap timer (NAP function)
Using the NAP function, you can set a timer alarm that will wake you up with an
alarm signal after 1–120 minutes.
Setting the nap timer
♦ Call up the system menu. The first menu item to appear is the NAP timer.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection.
♦ Press the TUNE+
8 or the TUNE− button7 or turn the VOLUME |
ENTER / SCAN dial6 to set the alarm time in 1-minute steps
between 001 and 120 minutes.
♦ Press the VOLUME |
ENTER/SCAN dial6 to confirm the selection
and start the nap timer. After exiting the system menu, N appears on the
display
1 followed by the remaining minutes or seconds.