Silvercrest SRH 5 C3 - Page 26

GB
│
IE
│
NI │ 23 ■
SRH 5 C3
Unpairing devices
If you want to connect the radio to another external playback device, you must
first unpair the currently connected playback device:
♦ Press the SOURCE /
button 3 for about 2 seconds. You will hear a
beep
and the display1 shows the message BT Pairing. Alternatively,
you can unpair via the currently connected external playback device.
Button functions during playback via Bluetooth
®
Button Function
VOLUME |
ENTER / SCAN6
► Press briefly to start/stop playback.
TUNE+
8
► Press briefly to move to the next track.
TUNE−
7
► Press briefly to go to the beginning of the
current track. Press briefly again to go
back to the previous track.
SOURCE /
3
► Press for approx. 2 seconds to unpair the
devices.
NOTE
► Depending on the external playback device being used and the operating
system, the volume on the radio and on the external playback device can
be adjusted independently of each other. For example, if the volume of the
radio is set to maximum and the volume of the external playback device is
set to minimum, you will hear nothing through the radio.
► Depending on the external playback device being used and the operating
system, it is possible that not all functions will be supported.
► In an environment with high-frequency interference, you may experience
noise interference during music playback in Bluetooth
®
mode. As soon
as the interference has ceased, music playback should automatically
continue in Bluetooth
®
mode without any further problems.