Silvercrest SRH 5 C3 - Page 41

■ 38 │ GB
│
IE
│
NI
SRH 5 C3
Fault Possible cause Remedy
No sound.
The device is not switched
on.
Switch on the device by pressing the
button2.
The volume is set to mini-
mum.
Increase the playback volume with the
VOLUME |
ENTER / SCAN
dial
6.
In AUX IN mode, the exter-
nal playback device is not
turned on.
Switch on the external playback
device.
In AUX IN mode, the
external playback device
is muted.
Unmute the external playback device.
In AUX IN mode, the
audio cable is not properly
connected to the AUX IN
socket w.
Make sure the
audio cable is correctly
connected to the AUX IN socket
w.
Interference with the
radio reception.
Radio reception is too
weak.
Pull out the telescopic aerial
0
completely. Try to improve reception
by moving the telescopic aerial 0
or by moving the radio to another
location.
No automatic
setting of time and
date.
The RDS signal is not
available.
Pull out the telescopic aerial
0
completely. Try to improve reception
by moving the telescopic aerial 0
or by moving the radio to another
location.
NOTE
► If you cannot solve the problem with the solutions given above, please
contact the Service Hotline (see section Service).