Silvercrest SRWK 800 A1 - Advanced Timer and Sleep Functions; NAP Function Details; Sleep Function Operation

■ 22
│
GB
│
IE
│
NI
SRWK 800 A1
♦ When the NAP function is activated, press the SLEEP/NAP │
12 / 24 button 8 for about 2 seconds to show the remaining
alarm time.
♦ When the alarm time has elapsed, an alarm signal sounds and
the display 1 shows ZZZ. Press the /AMS button 4 to switch
off the alarm.
NOTE
► To turn off the NAP function before the alarm time ends,
press the SLEEP/NAP │12 / 24 button
8 for about 2
seconds. Then, press the SLEEP/NAP │12 / 24 button 8
several times briefly until OFF is shown on the display 1.
Automatic switch-off (SLEEP function)
You can use the SLEEP function to switch off the device automatically
after 5–120 minutes.
♦ Press the SLEEP/NAP │12 / 24 button
8 briefly. SLEEP and
120 appear on the display 1.
♦ Press the SLEEP/NAP │12 / 24 button
8 repeatedly to set the
SLEEP time (120, 90, 60, 30, 15, 10, 5 minutes). After about 3
seconds, the normal display appears again and the SLEEP function
is started automatically. SLEEP appears on the top of the display 1.
After the set time, the device will switch itself off automatically.
♦ While the SLEEP function is activated, press the SLEEP/NAP │
12 / 24 button 8 briefly to show the remaining time until the
device switches off.
♦ To deactivate the SLEEP function, press the SLEEP/NAP │
12 / 24 button 8 repeatedly until OFF is shown on the display 1
or switch off the device with the
/AMS button 4.