Silvercrest SRWK 800 A1 - Troubleshooting; Display and Sound Problems

GB
│
IE
│
NI
│
25 ■
SRWK 800 A1
Troubleshooting
The following table helps to identify and rectify further possible faults:
Fault Possible cause Remedy
There is nothing
on the display
1.
The device is not
switched on.
Switch on the device
by pressing the /
AMS button 4.
The mains cable
q
is not connected
correctly.
Make sure that the
mains cable
q is
correctly connected
to a mains socket.
The mains socket is
not supplying any
power.
Check the house
mains fuse.
In standby mode, the
display
1 is auto-
matically switched
off between 11 pm
and 4:59 am (night
mode). During this
time, permanent light-
ing in standby mode
is not possible.
This is not a technical
error, this is a charac-
teristic of the device.
No sound.
The device is not
switched on.
Switch on the device
by pressing the
/
AMS button 4.
The volume is set to
minimum.
Increase the volume
using the VOLUME/
HOUR
‒
/+ dial
2.