GB
│
IE
│
NI
│
23 ■
SRWK 800 A1
Display lighting (DIMMER)
You can adjust the brightness of the LED read-out on the display 1 in
two steps or switch it off completely.
♦ In radio mode, press the SNOOZE/DIMMER button
6 to
increase or decrease the brightness of the display 1 in stages or
switch it off completely.
NOTE
► In standby mode, the display
1 is automatically switched off
between 11 pm and 4:59 am (night mode). During this time,
permanent lighting in standby mode is not possible and cannot
be switched on again permanently for a short time by pressing
a key. Each time a button is pressed, the display 1 lights up at
the brightest level for 5 seconds.
► The brightness remains at the currently selected level except for
between the hours of 11 pm and 4:59 am (night mode).
To Next Page
Loading...
