Silvercrest SSR 576 A1 User Manual

Digital SD Sat Receiver SSR 576 A1
English - 24
HDMI mode
Here you can optimise the picture resolution for
HDMI output. Please note that the picture may
disappear when switching the resolution. The
following settings are available:
576i DVI, 576p DVI, 576i, 576p, 720p and 1080i.
For optimum resolution on a modern flat-screen
display we recommend using the 1080i or 576i
setting.
Note: The 576i DVI and 576p DVI settings will
not send any sound signal via the HDMI
connector.
HDMI audio mode
Here you can adjust the HDMI connector audio
mode. Select the format supported by the
connected devices. The following settings are
available: "PCM" and "SP/DIF".
Volume bypass
Here you can specify if you want to control the
volume via your satellite receiver or an external
device. Select "Off" to control the volume from
your satellite receiver. When selecting "On" the
satellite receiver will output the maximum
volume and the volume can be controlled via the
connected external device only.
Digital audio
Select the digital audio formats supported by the
connected devices. The following settings are
available: "PCM", "PCM, DolbyD", "PCM, dts"
and "PCM, DolbyD, dts".
Timer Configuration
Timer pre-time
Press the – (29) or + (41) buttons to select the
timer pre-time between 0 and 30 minutes. If you
have programmed a timer via EPG, the timer will
start the set time earlier.
Timer post-time
Press the – (29) or + (41) buttons to select the
timer post-time between 0 and 30 minutes. If you
have programmed a timer via EPG, the timer will
stop the set time later.

Silvercrest SSR 576 A1 Specifications

General

Brand	Silvercrest
Model	SSR 576 A1
Category	Receiver
Language	English