English – 19
7.7. Dimmer function
You can adjust the display brightness in three levels as follows:
` Press the button repeatedly until you reach the desired brightness.
` Press and hold the button for approximately 2 seconds. The display turns off and
does not appear until you operate the device again. If the device is not operated for
about 10 seconds, the display turns off again.
` Press the button briefly to deactivate this function.
7.8. Setting the time/automatic dimming
When the device is switched on for the first time, the date and time are set using the radio
signal. The time can also be set manually. The automatic dimming of the display is also set
during this process:
` In standby mode, press and hold the button until 24 H flashes on the display.
` Press the or buttons to select 12- or 24-hour format and press to confirm.
` Press the or buttons to set the required hour and press to confirm.
` Press the or buttons to set the required minutes and press to confirm.
` Press the or buttons to set the desired day of the week (D1 = Monday, D2 =
Tuesday etc.)
` Press to confirm.
AUTO DIM appears on the display. You can dim the display automatically for a specific
period of time.
` Press the or buttons to select ON or OFF.
` Press to confirm.
` DIMSTART appears. Press the or buttons to set the desired hour for the dimmer
start time and press to confirm.
` Press the or buttons to set the desired minutes for the start time and press to
confirm.
` DIM ENDS appears. Press the or buttons to set the desired hour for the dimmer
end time and press
to confirm.
` Press the or buttons to set the desired minutes for the end time and press
to
confirm.
If you do not press any button within 7 seconds, the device switches back to standby
mode.
In the menu, you can select whether the time and week day are to continue to
be set automatically using the radio signal. For more information, see “12. Set-
tings menu” on page 24, menu item SYSTEM/AUTO TIME SYNC
To Next Page
Loading...
