Silvercrest SURQ 4 A2 - Setting the Alarm Time; Stopping the Alarm Tone;Activating the Snooze Function; Alarm Times; NAP Timer

English – 23
10. NAP timer
Set a short-time timer to activate an alarm signal after a set duration.
` In standby mode, press the button several times until the required duration (5–120
minutes) has been set in 5-minute increments.
` You can also fine-tune the duration in 1-minute increments using the  or  buttons.
NAP is shown on the display and an alarm signal sounds once the set time has elapsed.
` When the alarm sounds, press the
button to stop the alarm.
` To cancel the short-time timer before the alarm sounds, press the button repeatedly
or press and hold the button until OFF is shown on the display and NAP disappears.
11. Alarm times
It is possible to set two alarms at different times. The alarm will either trigger an alarm tone
or switch on the radio. In addition, you can implement the alarm daily or only on certain
days.
11.1. Setting the alarm time
` If you wish to be woken by the radio, first select a radio station in DAB or FM mode.
The last radio station set is used for the alarm.
` If the device isn’t already in standby mode, press to switch to standby mode.
` Press and hold the / button until the hour of the selected alarm time flashes.
` Use the  or  buttons to select the hours of the alarm time and press the respective
alarm time button or to confirm.
` Use the  or  buttons to select the minutes of the alarm time and press the respective
alarm time button or to confirm.
` Use the  or  buttons to set how regularly the alarm should be started: daily (17),
weekdays (15), weekends (67), once (1T) and press the respective alarm time but-
ton or to confirm.
` Use the  or  buttons to select what you want to wake up to: alarm (BB), DAB ra-
dio (DAB), FM radio (FM) and press the respective alarm time button or to
confirm.
` Use the  or  buttons to select the volume of the alarm and press the respective
alarm time button or to confirm.
When the alarm is switched on, the respective symbol with the selected alarm tone is
shown on the display (AL 1) and/or (AL 2).
11.2. Stopping the alarm tone/activating the snooze
function
When the alarm tone sounds you can deactivate it by pressing until the next alarm time
or activate the snooze function by pressing SNOOZE. When the alarm is snoozed, the
symbol flashes on the display. The alarm will then sound again after approx. 9 minutes.