20 – English
8. Radio mode
You can use this device to receive FM and DAB stations.
Your device has the Dynamic Label Segment (DLS) information service, which displays in-
formation such as artist, song titles or current traffic news on the display.
Configure the basic settings as described in section “12. Settings menu” on
page 24.
8.1. DAB mode
` When the device is switched on, press the button several times until DAB is shown
on the display.
8.1.1. Calling up DAB stations
` Set the desired DAB station by pressing the or buttons once or several times.
The selected station is played a few moments later. Stations in the station list that cannot
currently be received are marked with OFF AIR.
8.1.2. Storing stations automatically
A station list including all DAB stations that can be received was already created the first
time the device was switched on. The stations are stored in alphabetical order.
You can, however, also manually perform a new search:
` Press and hold the button. The search is performed and all stations found are stored
again. The search progress and the number of stored stations are displayed.
The previously stored station slots are overwritten.
8.1.3. Searching for DAB stations manually
` Press and hold the button to open the menu. FULL SCAN appears.
` Use the or buttons to select MANUAL.
` Press the button to confirm.
` The first reception block 5A with the corresponding frequency is shown on the display.
` Use the or buttons to select the required reception block. Familiarise yourself with
the blocks that can be received in your transmission area.
` Press the button to open the channel. If the frequency is occupied with stations, > > |
> > > > > appears on the display. If the frequency is not occupied by stations, |
appears on the display.
` Press the button again to store the station.
When a manual search is performed, the previously stored station slots are not
overwritten. The newly found stations are simply added.
To Next Page
Loading...
