Silvercrest SURQ 4 A2 - FM Mode

English – 21
8.1.4. Storing DAB stations
You can store 30 preset DAB stations.
` Set the required DAB station as described above.
` Press and hold the button to open the menu. FULL SCAN appears.
` Use the  or  buttons to select PRESET STORE.
` Press the button to confirm.
` E01 EMPTY (or a memory slot occupied by a station) is shown on the display.
` Use the  or  buttons to select a memory slot.
` Then press the button to store the station. STORED will appear on the display.
8.1.5. Calling up DAB stations
` Press the  or  button repeatedly to display the desired memory slot.
8.1.6. Display information/select views
` Press the button repeatedly to view the following information on the display:
• Station name • Signal fault
• Radio text • Bit rate
• Signal strength • DAB variants
• Programme section • Time
• Multiplex • Date
• Block/frequency
8.2. FM mode
` When the device is switched on, press the button several times until FM is shown on
the display.
8.2.1. Storing FM stations automatically
` Press and hold the button. The search is performed and all stations found are stored.
The search progress and the number of stored stations are displayed.
The previously stored station slots are overwritten.
8.2.2. Searching for FM stations manually
` Press and hold one of the  or  buttons to start an automatic station search back-
wards/forwards. The station search stops when the next strongest station signal is
reached.
` Briefly press the  or  button to switch to the previous/next frequency in 0.05MHz
increments.